Ceramic Electrode

Ignition Electrodes are used for the ignition of gaseous fuel in gas combustion equipment, which works on the principle of ignition by high-voltage flashover. The central electrode must not be permanently positioned in the flame. The ignition electrode and the ionisation probe are usually positioned together in the combustion chamber of the gas combustion equipment - gas-fired boilers, instantaneous water heaters, gas ranges, cookers etc. Ignition electrodes can be used as ionisation probes and vice versa. However their layout should always be respected, i.e. the ignition electrode must be out of the flame and only the central electrode in the flame. Ignition electrodes and ionisation probes are manufactured of high-quality materials. The insulator is made of the OXAL ceramics with high Al2O3 content. Characteristic features of this material are high mechanical strength and resistance to thermal and electrical load (electric strength of the insulator is 18kV). The central electrode is made of a special fire-proof material (kanthal) which is resistant to high temperatures and electrochemical corrosion. High quality gas ignition ceramics ignition electrode wildly using on Comercail gas burner for Boiler, Oven, with high insulation, well oxidation and impact resistant, sevice life more than 10,000 times, made by 95%AL2O3 Ceramic with glazed surface for insulating 18KV under 1300~1450 °C,center rod diam 1.6~2.0mm ferritic iron-chromium-aluminium alloy (0CR25AL5) suffer 1100~1250 °C

Description

We can offer a wide range of products, including gas pressure regulator, ceramic electrode (spark plug), thermocouple, air pressure switch, gas valve, ODS & pilot burner assembly, exhaust pipe, die, piezo igniter, 3-way Actuator, hydraulic group, flow sensor, 3-Bar safety valve, pressure gauge, water pressure switch, water flow switch, sparker, pulse controller, piezo cable, pulse igniter, blade Burner and so on...

Ceramic Electrode product description:

Type	Ceramic Electrode
Apply To	Gas water heater and other gas appliance
Application	Ignitor carries high-voltage ignition through electrode
Gas Source	NG/LPG
Material	Electrode Body-Ceramic,95% Al2O3;Glazing or no glazing
	Cable-UL1332,UL3573,UL3304,UL3257,UL1911,UL1659,UL10362 and so on.
	Rod(Pin)- FeCrAl or KANTHAL
Tip	Round or flat
Holder	With or without;punched or screwed
Temperature Resistance	Ceramic and Rod:≥1200℃
Temperature Resistance	Cable:≤250℃
Port	Shanghai or Ningbo

This is a ceramic electrode used in gas water heaters and other gas appliances. It is mainly assembled with high temperature resistant alumina ceramics and high temperature resistant alloys, high temperature and high voltage wires and terminals. Used for igniter to perform high voltage ignition at the electrode. The product has the advantages of rapid ignition, strong electrical conductivity, long service life, high insulation strength, high temperature resistance and oxidation resistance. The electrode body ceramic is 95% Al2O3, glazed or unglazed. The cable adopts UL1332, UL3573, UL3304, UL3257, UL1911, UL1659, UL10362 and other high temperature resistant heating wire, FeCrAl or KANTHAL ignition pin core material. Offshore port: Ningbo

Ceramic Electrode tip:

Ceramic Electrode